Electrical Requirements
Your booth operates from a
208V AC
source. You should have a
NEMA
6-30R
electrical outlet (below), on a dedicated circuit capable of pro-
viding
30 Amp service
, installed in the room in which you will use
the unit. We recommend installation by a professional electrician. The
outlet must be earth grounded.
30 AMP NEMA #6-30R
RECEPTACLE
DANGER
Shock hazard.
Disconnect power before servicing or removing any pro-
tective covers.
Do not operate this device near water or while you are
wet.
DANGER
Some medications may increase your sensitivity to ultraviolet light. It
is recommended that you consult a physician before using this booth if
taking any medication, or if you suspect that your skin might be espe-
cially sensitive to sunlight.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
CAUTION
Air from the room is used to cool the unit. Maximum ambient room
temperature should be 80°F. Place your booth no closer than 6” from
any wall. Make sure nothing obstructs the airflow into the booth’s
endcaps or out of the fan openings. A poorly ventilated room may
cause the unit to become hot and cause discomfort to the user.
Unpacking and Inspection
Your booth arrives in three cardboard cartons. Pull back the plastic
sheet and, with a helper, grasp each unit and pull it from the carton
bottom, leaving the plastic wrap and the carton packaging. Do not try
to lift the unit with the plastic still on as it may slip.
The Control Unit box contains the hardware kit and a body fan.
Inspect the items and make sure they are free from any visible damage.
Report the extent of any damage to the transportation company.
Hardware Inventory
(Plus a small pillow and eyewear)
Shoulder Bolt
Quantity 4
Flanged Sleeve Bushing
Quantity 4
Nylon Flat Washer
Quantity 4
3/8” Washer, Black
Quantity 4
Hex (Allen) Wrench
Quantity 1
3/8-16 Locknut, Black
Quantity 4
10351A
You Will Need:
#2 Phillips
Screwdriver
9/16” Wrench
Platinum
Assembly Procedures
Connect the Side Unit to the Control
Unit (with timer), as shown. Both units
have legs. The Door Unit has wheels.
Be sure the white Nylon Washer is be-
tween the hinge brackets.
1
CONTROL UNIT
LEGS
#12 x 3” Screw
Quantity 1
PRO
48
X
