Suncast HomePlace Bungalow, Assembly Manual

Page: 9 / 42

Bottom Wall Plate Layout
for Units without floor
Step 10: Cut open large package and remove packing materials repeating step 1.
Step 11: Remove top layer of
4’x8’ OSB roof sheeting and
set aside.
Step 13: Remove screws from
4’-2”x4” double wall plates
and set aside.
Note: If you purchased the optional floor, please proceed to back wall layout and assembly page.
Step 12: Remove next layer of
kit and set aside.
Step 14: Remove all remaining
pieces (excluding pressure
treat 2”x4” bottom wall plates)
and. Step 15: Measure a square
pad at 140”x192” and snap
lines as shown. Make sure
layout is square, see step 19.
Note: The measurement for
a 12’x20’ unit is 140”x240”.
Wall Plate 2”x4”Material List*:
10 - 8’ 6 - 25”
4 - 4’ 6 - 7’
*For a 12’ x 16’ size
page 8
©
Suncast Corporation