7
Dry ironing
Follow steps 1 and 2 above.
3. Select DRY on the STEAM/DRY dial. This
will cut off the steam flow if there is water
in the tank.
Steam ironing
Follow steps 1 and 2 above.
NOTE: When steam ironing, ensure that the
temperature dial is set to any temperature
within the steam band, and that the tank is
at least 1/4 full of water.
3. Turn the STEAM/DRY dial to the desired
steam setting.
For best results, select the steam setting that
corresponds to the selected temperature, as
indicated on the temperature dial.
Using the shot of steam
The shot of steam can be used when dry
or steam ironing, when the temperature dial
is set to any temperature within the steam
band or above the two dot (••) setting.
1. Ensure the tank is at least 1/4 full of
water.
2. Select the desired temperature and wait
until the boost light goes out.
3. Press the shot of steam button several
times with the iron on the soleplate to
prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after
filling the iron with water.
Using the spray mist (SR5555 & SR5540)
The spray mist can be used whether dry
or steam ironing to pre-dampen hard
to iron fabrics.
1. Ensure the tank is at least 1/4 full of
water.
2. Press the spray button during ironing to
release a fine mist from the spray nozzle.
Using your Sunbeam Ultura Iron (continued)
