3
Before first use
Remove any adhesive stickers, plastic covers
or cardboard sleeves from the soleplate.
Ensure that all adhesive is removed by
rubbing the soleplate with a cloth
dampened with methylated spirits.
NOTE:
When turned on for the first time,
your new iron may give off vapours for up
to 10 minutes. This is due to the initial
heating of the materials used. It is safe, not
detrimental to the performance of the iron,
and will not reoccur.
Using your iron
1. Insert the 3 pin plug into a 230/240 volt
power outlet and turn the power on.
2. Turn the temperature dial to the desired
setting by aligning the setting on the dial with
the temperature indicator. The thermostat
light will illuminate to indicate that the iron
is heating to the selected temperature. When
the thermostat light goes out the iron is at
the selected temperature and is ready to iron.
NOTE:
When the temperature dial is changed
from a high setting to a lower temperature
setting during ironing, the thermostat light
will go out immediately. This indicates
that the iron is cooling to the selected
temperature. To ensure that the iron has
reached the selected temperature and is not
too hot, wait until the thermostat light comes
on again and then goes out before ironing.
Using your Ultura Dry Iron
Care and Cleaning
After each use
1. Turn the power off and remove the plug
from the power outlet.
2. Allow the iron to cool before winding
the cord around the built-in cord wrap.
Storage
Always store the iron on its heel rest.
NOTE:
Do not store the iron with the soleplate
facing down, or in the carton.
Cleaning
To clean the exterior of your iron, wipe
over with a damp soft cloth and wipe dry.
Caution:
Do not use harsh abrasives, chemical
cleaners or solvents to clean the exterior of
your iron as these will damage the surface.
Cleaning the Teflon® Platinum Pro non-stick
soleplate
The non-stick coating reduces sticking of
fabrics and starches to the soleplate. Do
not iron over sharp objects such as buttons,
studs and zippers, as these will scratch the
surface.
Wipe the soleplate with a damp soft cloth
after each use. If polyester has burnt to the
soleplate, iron a damp cotton cloth while hot.
Caution:
Do not use scouring pads, abrasives
or harsh cleaners to clean your Teflon®
Platinum Pro soleplate, as these will scratch
and damage the surface.
