Heading
Follow the instructions below for the type of
electric blanket you have purchased.
A double/queen size electric blanket can
safely be used on a double bed, providing the
heating wires do not overhang the edge of the
mattress. Do not tuck in.
Tie tape electric blankets
Place the electric blanket on your mattress
towards the foot of the bed. The control
sockets should be under the blanket near
the head of the bed. Ensure that the heating
wires do not extend under the pillows, or
hang over the sides of the mattress (see
Figure 1). Smooth any folds or wrinkles.
A single electric blanket can be turned over
so that the control is on the preferred side of
the bed if desired. Please note that this may
result in the control facing towards the bed
once the bed is made.
Pull the tip of each tie tape and unroll. As
shown in Figure 2, pass the tape from (A)
under the corner of the mattress and through
the loop at the base of the bed (B), then
under the other corner and through the loop
(C). Secure the tie tape firmly with a knot.
Repeat at the head of the bed.
Pass the tie tape in the middle of the blanket
underneath the mattress and through the
corresponding loop on the other side. Secure
firmly with a knot. Avoid tying small, tight
knots, which may make it difficult to remove
the blanket.
Fitting your electric blanket
Figure 1.
Figure 2.
C
A
B
13
Summary of Contents for Safe & Sound
Page 22: ...Notes...