Sunbeam Arctic Dawn, User Manual

Page: 4 / 25

2
DD Remote
Features:
• REMOTE CONTROL – sends heat level control commands to the base unit
and adjusts the blankets warmth accordingly.
• ELECTRONIC DIGITAL CONTROL – for easy setting with backlit LCD
• AUTO-OFF – 10 hour independent auto-off (see page 15)
• 10 TEMPERATURE SETTINGS – select your personal comfort
• PRE-HEAT – for cozy warmth before bedtime
• SOLID STATE – for accurate and consistent heat control
• EASY OPERATION – Electronic digital controller for easy operation
• EASY GRIP – ergonomic control for easy operation
• CORDLESS – no more wires to tangle
• AUDIBLE BEEP – when changing heat settings, on/off setting and
automatic programming selections.
Pre-heat
1 To use the preheat feature, simply press the round “On/Off” button and
then press the “Preheat” button. The preheat function will heat the bed for
a period of 30 minutes.
2 To reset the preheat feature, simply press the “On/Off” button OFF.
3 To turn back ON repeat step1.
CAUTION: Do not plug main power cord into the wall outlet until you have completely set
up your warming blanket per the instructions.
IF YOU DO NOT FOLLOW THIS SEQUENCE, THE WARMING BLANKET WILL NOT WORK.
• Disconnect power cord from wall before detaching control from warming blanket
• Always make sure cords are NOT trapped or pinched between bed slats, mattress,
springs, against wall, foot board or bed frame.
1 Place the warming blanket on the bed with the label side facing outward.
2 Plug cord into the module at the bottom of the warming
blanket until the plastic hinges click into place.
CAUTION:
Cord must be COMPLETELY CONNECTED. A risk of fire could
result from a loose connection.
3 Run the cord under the bed, not between the mattress and box
springs. Avoid any tangling or pinching.
4 Place the base unit on the floor under the bed.
5 Place the remote control where it is convenient for you.
6 Plug warming blanket power cord into a 110-120 volt wall
outlet.
CAUTION: This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electrical shock, this plug is intended to
fit only one way into an outlet. If the plug does not fit in the outlet, reverse
the plug. Do not attempt to force the plug.
6
2
IMPORTANT
2
1
2
3
4
5
6
Set Up
WARMING BLANKET