a Steam Iron
When using as a steam iron be sure the temperature setting is within the STEAM range on the
temperature selector to avoid spotting the garment.
l
Slide the temperature control to MIN. Slide top button to the steam position,
Fill the iron with water. (See TO FILL THE WATER TANK instructions),
l
Plug the cord into a 120 volt, AC electrical outlet.
l
Move the temperature control to the appropriate fabric setting. Allow 2 minutes for the iron
to reach the desired temperature.
l
After iron has reached desired temperature, remove from the heel rest and use. If the unit fails to
steam after depressing the steam slide button, gently tap the soiepiate on the ironing surface.
This will aid in starting the steaming action.
l
‘When steam ironing, if the temperature control setting is accidentally lowered, water may appear
on the soleplate, indicating that iron temperature has dropped below steaming level. If this,
should occur, reset temperature control to desired level. Rest the iron on its heel rest for 1 minute
to allow it to reach temperature. if your iron starts losing its flow of steam and you wish to
continue steam ironing, you may refill without cooling the iron, Unplug the iron, Follow the TO
FILL THE WATER TANK instructions. Add water only to the maximum fill line to prevent overflow.
To Fill the Water Tank
Always unplug the iron before filling. Set iron on its heel rest,
The water fill opening is located underneath the spill-proof cap. Hold the iron
with the cap open and fill to maximum fill line. Close the spill-proof cap
on the iron. Be sure the cap is fully seated. Wipe the exterior of the unit
to dry off any spillage.
To Empty the Water Tank
Slide the temperature selector to the MIN position. Unplug the iron from the electrical outlet.
Open the spill-proof cap. Holding the iron over the sink, point the iron handle down and hold in
that position until water stops flowing out of the fill opening. Shake the iron gently to loosen trapped
water drops; the heat of the iron will dry the inside of the iron. Let the iron cool on its heel rest.
IMPORTANT: SUNBEAM DOES NOT RECOMMEND STORING THE IRON WITH WATER IN THE TANK.
Caring for Your Sunbeam Iron
l
Avoid ironing over snaps, zippers, rivets on jeans, etc., as they will scratch the soleplate.
l
FOR MODELS WITH A NON-STICK OR CHROME-PLATED SOLEPLATE, clean water marks,
calcium deposits and starch from the soleplate as follows: allow iron to cool and wipe with a soft
cloth using a mild vinegar solution (one tablespoon of vinegar in one cup of water).
DO NOT USE
SCOURING PADS, ABRASIVES, OR CHEMICAL CLEANING SOLVENTS as they may mar the
finish. NOTE: Scratches in non-stick soleplates do not affect performance of iron.
Maintenance
Other than recommended care instructions contained in this pamphlet, no further user maintenance
should be necessary.
However, following is a list of frequently asked questions and their resolutions. However, if for any
reason your Sunbeam iron continues to exhibit one of these symptoms, or should require repair for
another reason, do not attempt to fix it yourself. Send it to the Sunbeam Appliance Service Center.
6
