F i b e r O p t i c S o l u t i o n s P r o v i d e r
3/8
www.suntelecom.cn • +86-21-60138638 • [email protected]
cabinet.
3
Use and maintenance
3.1 Working principle of the cabinet see picture 2.
Picture 2
3.2 Strip fiber cable
3.2.1
Strip the fiber cable from where is 2800mm away from the end to strip.
3.2.2
Cut crosswise the outer sheath before stripping with the special stripping
knife and carve scratch on the steel strip (but not cut) and then gently bend it
back and forth until it break. Remove the disconnected steel strip together
with the outer sheath to expose the integrated aluminum sheath.
3.2.3
Take two checking rings and one hose clamp, whose diameter is similar
with the diameter of the fiber cable and put it into the fiber cable in turn.
3.2.4
Starting at the end of the integrated aluminum sheath, cut 1800mm of
the PR inner sheath and LAP layer and remove the sheath. Be patient to
avoid damaging the fiber loose tube.
3.2.5
Lengthwise cut 30mm along the sheath direction at the integrated
aluminum sheath breaking point and then crosswise cut 10mm. at this time
you will see the L-shaped incision as picture 3 shows.
3.2.6
Cut the winding wire and wrapping tape, and round up the aramid cord.
Leave 150mm for the wrapping tape and aramid cord.
