Sun Oracle Storage Tek T10000, Reference Manual

Page: 214 / 296

Request Sense Command
196 T10000: Interface Reference Manual • January 2011 • E20425-01
4 4B 82 DMA error during data phase
51 00 Erase fault
52 00 Cartridge fault (a load/eject command failure reported by CSL)
53 01 Unload tape failure (tape unload check)
5 1A 00 Parameter list length error (mode select or other parameter data was
truncated)
20 00 Invalid command operation code (first byte of CDB is not a supported cmd)
21 00 Logical block address out of range
24 00 Invalid field in CDB (unsupported or illegal bits are set, field pointer
indicates where)
24 80 Write command has 1 through 4 as an invalid transfer count for the Data
Protection mode selected
24 81 Write command has non modulo 4 or less than 8 as an invalid transfer
count for the Data Protection mode selected
24 82 Media loaded in drive (attempted Write Buffer or Read Buffer command
with tape in the drive)
24 8E Invalid firmware image
25 00 Logical unit not supported (only LUN 0 supported)
26 00 Invalid field in parameter list (unsupported or reserved bits are set, field
pointer indicates where)
26 04 Invalid release of Persistent Reservation
26 11 Incomplete key-associated data set
2C 00 Command sequence error
30 02 Incompatible format
39 00 Saving parameters not supported
3B 0C Partition past beginning of partition
3F 0F Echo buffer overwritten
4B 90 FCP_DL field not sufficient to complete the transfer
80 00 CSL not present (a load command was issued, but CSL not installed)
80 01 Invalid CSL position requested
Table 150. Sense Key with ASC and ASCQ (Continued)
Key Byte
Description 12 13