Sun Microsystems Ultra 1 140, Service Manual

Page: 143 / 176

System Board and Component Replacement 10-21
10
Figure 10-18 DSIMM Ejection Lever
3. Pull the DSIMM out of the socket.
10.4.2 Replacing a DSIMM
1. Take the replacement DSIMM from the antistatic container.
2. Position the DSIMM in the socket so the notch is on the same side as the
lever.
See Figure 10-19.
Note – The replacement DSIMM should have the same capacity as the
defective DSIMM.
3. Insert the DSIMM into the socket by pushing it down at both ends until
it is fully seated in the socket.
See Figure 10-19.
Ejection lever
DSIMM
DSIMM