Sun Microsystems TurboGX, Installation Manual

Page: 75 / 82

F-1
Installing an SBus Card Bracket
Adapter and Handle
F
This appendix provides installation instructions on how to install the bracket
adapter, and card handle before installing the SBus card into the following
systems:
•
SPARCstation 1 and 1+
•
SPARCstation 2
•
SPARCstation IPC
• SPARCstation IPX
•
SPARCstation LX
•
SPARCclassic
•
SPARCclassic X
•
SBus Expansion Subsystem
Note – Before the SBus card can be installed, the system needs to be powered
down. If powering down this system affects other users or clients, the system
administrator should warn them that the system is about to be powered down.
For details refer to the system software documentation.
F.1 Handling Internal Components
Keep in mind that many of the internal components of the system unit are
delicate and sensitive to electrostatic discharge. The antistatic wrist strap
should be attached to your wrist and to a bare metal portion of the system unit
chassis, such as the power supply, before handling the boards or internal
components. Failure to comply may result in permanent damage to a board.
Caution –
Handle the card only by the non-conductive edges. To avoid damage
to the card, do not touch the components on the card or any metal parts. Make
sure the system power is turned off and the power switch is in the off position.
Also make sure that the green light-emitting diode (LED) at the front of the
system is not lit.
!