Sun Microsystems Sun Fire T200, Installation Manual

Page: 49 / 80

Chapter 2 Installing the Sun Fire T2000 Server 29
▼
To Connect the SC Serial Management Port
Use this port for server management. This port is needed to set up the SC network
management port, as detailed in
“Enabling the System Controller Network
Management Port” on page 38 .
The SC serial management port is marked SER MGT. It is the leftmost RJ-45 port on
the rear of the chassis (
FIGURE 2-18
).
FIGURE 2-18
System Controller Serial Connection
●
Connect a Category 5 cable from the SC serial management port to the terminal
device.
▼
To Connect the SC Network Management Port
The SC network management port is marked NET MGT. It is the RJ-45 port above
the rear USB ports.
Note –
This port is not operational until you configure the network settings
(through the serial managment port), as detailed in “To Configure the System
Controller Network Management Port” on page 39 .
SER MGT