Sun Microsystems StorEdge X6767A, Installation Manual

Page: 66 / 68

-22 Sun StorEdge 2G FC PCI Single Channel Network Adapter Installation Guide • May 2002
B.2.4.4 To Specify the New Boot Disk as the Boot Device.
1. Bring the host with the host adapter down to the
ok
prompt at run level 0.
See the Solaris system administration documentation on shutting down a host for
the commands that can be used with different configurations. The following screen
example uses the
shutdown
(1M) command.
2. Use the
nvalias
command to alias the device name of the disk to a short name
for the disk.
The following example uses
/pci@8,600000/SUNW,qlc@1/fp@0,0/disk@10,0
, which was the device path
name for disk 2 in Section B.2.2.2 “To Record the Partition Layout” on page B-9.
3. Use the
nvstore
command to store the new alias followed by the
reset all
command.
4. Define the new boot disk as the default
boot-device
.
Use the data gathered in Step 2 on page 10.
a. Enter the
setenv
command followed by the
boot-device
parameter followed
by the name of the new disk.
b. Enter the
reset
command.
# shutdown
...
ok
ok nvalias disk2 /pci@8,600000/SUNW,qlc@1/fp@0,0/disk@10,0
ok nvstore
ok reset-all
ok setenv boot-device disk2
ok reset