Sun Microsystems StorEdge N8200, Installation, Configuration, And Service Manual

Page: 7 / 28

Sun StorEdge N8200 Filer Installation, Configuration, and Service Guide 5
▼
To Connect the Cables and Power On the System
1. Connect the SCSI cable to the disk storage unit(s) and to the SCSI slot of the
controller.
If your system has multiple disk storage units, connect them to the controller SCSI
ports in the order shown in
FIGURE 2
. Thus, if you have two disk storage units, you
would connect them to slots 1 and 2.
FIGURE 3
shows the correct SCSI connections for
two disk storage units.
FIGURE 2
Controller Back Panel Connections
Power
Power
Network
SCSI Serial port A
1
2
4
(not used)
(console)
Controller SCSI connectors labeled in
3
order of connection to disk storage units