Sun Microsystems StorEdge 3000 Series, Installation, Operation And Service Manual

Page: 224 / 318

B-10 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
FIGURE B-2
Sun StorEdge 3510 FC JBOD Array Attached to a Single HBA Port
FIGURE B-2
shows an example of a Sun StorEdge 3510 FC JBOD array with 12 drives
connected to a host computer over a single loop to a single FC port. In this example,
the port is one of a pair of ports on a dual-port HBA.
In this example, if the loop ID switch is set to 0, the
format
command shows 12
drives on this loop, ranging from
c1t0d0
to
c1t11d0.
The drive identifiers are arranged in four columns of three drives each to reflect the
physical location of these drives in the array. They correspond to the locations of
Disk 1 through Disk 12 as shown in
FIGURE B-5
.
B.7.2 Dual-Port Connections to Sun StorEdge 3510 FC
JBOD Arrays
You can also connect a Sun StorEdge 3510 FC JBOD array to both ports on a dual-
port HBA, ports on two single-port HBAs, or a port on a single-port HBA and a
single port on a dual-port HBA.
TABLE B-3
Example of 12 Drives Shown on a 12-Disk Sun StorEdge 3510 FC JBOD Array
Connected to a Host Over a Single FC Loop
Drive Identifier
c1t0d0 c1t3d0 c1t6d0 c1t9d0
c1t1d0 c1t4d0 c1t7d0 c1t10d0
c1t2d0 c1t5d0 c1t8d0 c1t11d0
Host computer
JBOD array