Sun Microsystems StorageTek TIMBERWOLF 9740, Hardware Operator'S Manual

Page: 71 / 100

95693 Revision P A-1
A
Cartridge Tape Information
This appendix contains information about the cartridge tapes used in the
controller transport units (CTUs) and tape drives for the LSM.
■
Cartridge Requirements
Cartridges must meet specifications defined in American National Standard
Magnetic Tape and Cartridge for Information Interchange , ACS X3B5.
Refer to your drive vendor’s publication and Web site for specific cartridge
requirements and specifications.
Colored cartridges are approved only if the measured reflection density is
greater than 0.1 as measured by an X-rite 404G color reflection densitometer.
For more information about colored cartridges, contact your StorageTek
marketing representative.
■
Handling a Cartridge
Improper handling of cartridges can result in a loss of data or damage to a
library component. To handle a cartridge correctly:
• Make sure the leader block is latched every time you pick up a cartridge.
• Keep cartridges clean.
• Inspect a cartridge before each use, and never put a damaged cartridge into
a drive or library.
• Never release a leader block and pull tape from a cartridge.
• Never open a cartridge.
• Do not handle tape that is outside the cartridge; the tape edge might be
damaged.
• Do not expose the tape or cartridge to direct sunlight or moisture.
• Do not expose a recorded cartridge to magnetic fields; this might destroy
data on the tape.