Sun Microsystems StorageTek TIMBERWOLF 9740, Hardware Operator'S Manual

Page: 33 / 100

95693 Revision P 3-1
3
Operating the LSM
This chapter contains the procedures for:
• Powering-on or IPLing the LSM
• Powering-off the LSM
• Operating in automated mode
• Operating in manual mode
When the machine is controlled by the host, refer to your software publications
and enter the command from the operator console to do the desired activity.
■
Powering-on or IPLing the LSM
To power-on or IPL the LSM, lift the power switch at the bottom right corner of
the right front door of the LSM. When the LSM has been powered-on, you can
press the IPL function key located on the operator panel to IPL the LSM.
When you do either activity:
• The operator panel displays PROM, boot, and initialization information.
• The operator panel displays “
ONLINE - PRESS EXE TO UNLK CAP
.
Note: If the LSM does not power-on, contact the Central Support Remote
Center and report the problem.
■
Powering-off the LSM
To power-off the LSM, enter the command at the operator console to place the
LSM and controller transport units (CTUs) and drives offline.
Push down the power switch on the bottom right corner of the right front door
of the LSM.
If this is an emergency, press the power switch on the cartridge drive to the off
position. This is only applicable to 9490 and SD-3 Cartridge Drives.
If you have a standard or expanded (9741 or 9741E) Drive Cabinet with DLT, T9840, or
T9940 drives and you have an emergency, you must switch the circuit breaker off to kill
power to the drives.