8
Netra t1 4-Stack Memory Upgrade: Addendum • June 2000
8. If you are replacing the currently installed base memory board, align the
connectors of the new base board with the memory board sockets on the Netra t1’s
motherboard.
Press home fully the connectors using your thumbs. The connectors need to be
properly seated (see
FIGURE 7
). You might find it helpful to seat the middle connector
properly before the other two connectors.
FIGURE 7
Seating a Single Memory Board on the Netra t1’s Motherboard
Caution –
Although it is necessary for the connectors to be properly seated, you
must not apply excessive pressure to them. If you do, you might cause micro-
fractures on the motherboard which can impair the operation of the board.
9. Position the connectors of one memory board (Board C) above the memory board
connector sockets of another memory board (Board B) in a piggy-back style, then
press down the connectors using your thumbs until they are seated.
You might find it helpful to seat the middle connector properly first. See
FIGURE 8
.
Put together Boards B and C first, before you connect them to Board A.
Caution –
Place the memory boards on ESD foam during this assembly.
Board A
Motherboard
!
!
