Sun Microsystems Fire V240, Administration Manual

Page: 25 / 102

Chapter 1 Introduction 11
silent-mode? false
Suppress all messages if true and
diag-
switch?
is false
scsi-initiator-id 7
scsi-id of the scsi controller
oem-logo? false
If
true
, use custom OEM logo, otherwise,
use Sun logo
oem-banner? false
If
true
, use custom OEM banner
ansi-terminal? true
screen-#columns 80
Sets number of columns on screen
screen-#rows 34
Sets number of rows on screen
ttya-mode 9600,8,n,1,-
ttya (baud rate, #bits, parity, #stop,
handshake)
ttyb-mode 9600,8,n,1,-
ttyb (baud rate, #bits, parity, #stop,
handshake)
output-device ttya
Power-on output device
input-device ttya
Power-on input device
load-base 16384
Address
auto-boot? true
If
true
, boot automatically after power on
or reset
boot-command boot
Action following a
boot
command
diag-file none
File from which to boot if
diag-switch?
is
true
diag-device net
Device to boot from if
diag-switch?
is
true
boot-file none
File to boot if
diag-switch?
is
false
boot-device disk net
Device(s) from which to boot if
diag-
switch?
is
false
use-nvramrc? false
If true, execute commands in NVRAMRC
during server start-up
nvramrc none
Command script to execute if
use-
nvramrc?
is
true
security-mode none
Firmware security level (options:
none
,
command
, or
full
)
security-password none
Firmware security password if
security-
mode
is not
none
(never displayed) - do not
set this directly
TABLE 1-6
OBP Configuration Parameters Stored On The System Configuration Card
Parameter Default Description