Sun Microsystems 1.0, Service Manual

Page: 35 / 221

succeeded
You may also control the selection of Ethernet interfaces to monitor by using specific
commands. Use
watch-tpe
to monitor the 10BaseT (TPE) connection or
watch-aui
to monitor the 10Base5 (thick Ethernet) connection. For example:
ok watch-tpe
Internal loopback test -- succeeded.
External loopback test -- succeeded.
Looking for Ethernet packets.
’.’ is a good packet. ’X’ is a bad packet.
Type any key to stop.
............................................................
The
watch-net-all
command monitors Ethernet packets on any Ethernet interface
installed in the system. For example, if you have an SBus Ethernet card installed in
one of the system SBus slots,
watch-net-all
will start by monitoring Ethernet
transmissions detected by that card.
When you interrupt the test on that interface by pressing any key,
watch-net-all
then goes on to test the next Ethernet interface it finds in the system.
For example:
ok watch-net-all
/iommu@f,e0000000/sbus@f,e0001000/lebuffer@1,40000/le@1,60000
Internal loopback test -- succeeded.
External loopback test -- succeeded.
Looking for Ethernet packets.
’.’ is a good packet.
’X’ is a bad packet.
Type any key to stop.
...................................................................................(keyboard key pressed h
/iommu@f,e0000000/sbus@f,e0001000/ledma@f,400010/le@f,c00000
Internal loopback test -- succeeded.
External loopback test -- succeeded.
Looking for Ethernet packets.
’.’ is a good packet. ’X’ is a bad packet.
Type any key to stop.
..........................................................................................................
probe-scsi, probe-scsi-all
The
probe-scsi
test sends an inquiry command to internal and external SCSI
devices connected to the SPARCstation 10 on-board SCSI interface. If a SCSI device is
connected and powered up, the target address, unit number, device type, and
manufacturer name should be displayed. For example:
Diagnostics Overview
19