PG 7
PLATFORM
1.
Position the finished Seat Support and Ladder Assembly as
shown in
figure 7
.
Note: The welded U bracket faces the
tree when fully assembled.
Slide the Seat Support down onto
the Ladder Assembly and line up the bolt holes.
2.
Position the Platform Assembly as shown in
figure 8
.
3.
Slide the platform forward and line up the bolt holes from
Step 1.
4.
Position the Footrest. Line it up with the same bolt holes as
Step 1 and 3
. Insert a
1/4” Bushing
between the Footrest and
the Seat Support tubing.
(see figure 9)
5.
Secure the Footrest, Platform, Seat Support and Ladder
Section using two
2 3/4” bolts and lock nuts
(see figure 10)
.
Leave these bolts hand tight for now.
6.
Position one of the Platform Support bars as shown in
figure 10.
The bar should run from the inside of the Upright
to the outside of the Platform as shown.
7.
Secure at the upper and lower hole using one
1 3/4” bolt
and lock nut
. Leave these bolts hand tight until both bars are
attached.
8.
Repeat for the opposite side.
9.
Wrench tighten bolts from
Steps 5 and 7.
7
SEAT
SUPPORT
LADDER
ASSEMBLY
11
EXPANDED
METAL REMOVED
FOR CLARITY
PLATFORM
SUPPORT
(PN 82068.030)
1 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 9
8
PLATFORM
(PN 82068.100)
2 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 9
10
9
FOOTREST
(PN 82068.400)
BUSHING
WELDED
U BRACKET
FACES TREE
TOP LADDER
SECTION
