Section 1. Assembling Your Single Shot Ladder Treestand.
Please refer to the last three pages in this instruction booklet for
parts lists and exploded view drawings. Please contact us at www.
summitstands.com or 256-353-0634 to obtain any missing parts or
if your DVD does not work..
Part 1. Ladder Column Assembly.
Step 1.
Bolt together two of the bottom column assemblies. To do
this, lay both assemblies down and butt them together as shown in
Figure 1
. Lay one coupler plate across the joint and bolt together
using two 2 3/4” long bolts and lock nuts. See
Figure 2
. Repeat for
the other side.
Step 2.
Repeat this process again so that you have a total of 3 bottom
column assemblies bolted together. Set this assembly aside.
Figure 1
Part 2. Arm Rest and Platform Assembly.
Step 1.
Lay the top column assembly down as shown in
Figure
3
. Note that the welded on brackets are facing up and the rungs are
located to the right.
Step 2.
Bolt the arm rest assembly to the left most set of welded on
tabs. The two tabs on the arm rest bar must face toward the right as
shown in
Figure 4
. Use two 1 1/2” bolts and lock nuts to secure both
sides.
Step 3.
Bolt the platform assembly to the top column assembly. Use
the two holes drilled into the end of the platform tubing. You will
use the middle set of brackets on the top column assembly as shown
in
Figure 3 and Figure 5
. Note the orientation of the platform. The
welded on brackets will face toward the arm rest assembly bar and
smooth part of the rungs will face up. Use two 1 1/2” bolts with lock
nuts per side to secure.
For the following two steps, run all bolts from the inside out to put the
nut on the outside of the stand.
Step 4.
Attach one of the support tubes to the platform as shown in
Figure 6
. The bar will bolt to the
outside
of the platform bracket.
Use one 1 1/2 bolt and lock nut - hand tighten it. Run the support
tube to the lower bracket on the top column assembly as shown in
Figure 7
. The bar will bolt to the
inside
of this bracket. Use one 1
1/2” bolt and lock nut - wrench tighten. Go back and wrench tighten
the bolt at the platform bracket. Repeat for other platform to top
column support tube.
Step 5.
Attach one of the support tubes to the last remaining bracket
on the top column assembly as shown in
Figure 8
. The bar will bolt
to the
inside
of the bracket. Use one 1 1/2” bolt and lock nut - hand
tighten it. Run the support tube to the bracket on the arm rest bar as
shown in
Figure 9
. The bar will bolt to the
inside
of this bracket.
Use one 1 1/2” bolt - wrench tighten. Go back and wrench tighten the
bolt at the platform bracket. Repeat for other platform and support
tube.
Part 3. Attaching the Platform Assembly to the Ladder Column
Assembly.
Attach the platform / top column assembly to the three ladder col-
umns you bolted together earlier as shown in
Figure 10
. Use one
coupler plate per side and use the remaining 2 3/4” bolts and lock
nuts. Repeat for both sides.
Figure 4
Figure 7
1 1/2” Bolt and Lock Nut
1 1/2” Bolt and Lock Nut
