LEG ASSEMBLY (continued)
10.
Position one of the 12’ Leg Assemblies as shown in
figure 42.
The oval pre-punched holes
MUST
be on the far end of the Leg
Assembly. These holes are for the Spikes included with this tripod
11.
Slide the Leg Assembly into the Coupler Plate and secure using
one
2 3/4” bolt and lock nut
as shown in
figure 43.
12.
Rotate the tripod again and repeat Steps 7 - 11 for the other
Leg Assembly.
Oval hole must be
on far end of leg
assembly
12’ LEG ASSEMBLY
(PN 82072.1200)
42
2 3/4” BOLT, LOCK NUT,
WRENCH TIGHTEN
43
LEG BRACES
1.
Locate the pre-punched hole half-way down the Leg Assembly.
2.
Position one Bracket over this hole from the inside and secure
using one
2 3/4” bolt and lock nut
as shown in
figure 44
. As
before, the Bracket should run horizontal to the ground when the
tripod is standing up -
You must run this bolt from the inside
out so that the head of the bolt is sitting on the Bracket when
tight.
3.
Repeat for the other Leg Assembly and the Ladder Assembly
as shown in
figure 45
. Use one
2 3/4” bolt and lock nut
to secure
each Bracket.
You must run these bolts from the inside out so
that the head of the bolt is sitting on the Bracket when tight.
BRACKET
(PN 82072.1300)
44
2 3/4” BOLT, LOCK NUT,
WRENCH TIGHTEN
45
BRACKET
(PN 82072.1300)
BRACKET
(PN 82072.1300)
2 3/4” BOLTS, LOCK NUTS,
WRENCH TIGHTEN
BRACKET
(PN 82072.1300)
PG 10
