Summit Professional Pro24G, User Manual

Page: 21 / 37

Butane/propane Natural gas
Loosen the screw Tighten the
screw
1/2 round
CAUTION:
If the gas type of the unit is changed,
then the rating plate showing the gas
type must also be changed.
The California Safe Drinking Water and
Toxic Enforcement Act requires the
Governor of California to publish a list of
substances known to the State of
California to cause cancer, birth defects
or other reproductive harm, and requires
businesses to warn of potential
exposure to such substances.
IMPORTANT:
This product
contains a chemical known to the
State of California to cause cancer,
birth defects or other reproductive
harm.
This appliance can cause low-level
exposure to some of the substances
listed, including benzene, formaldehyde,
carbon monoxide and toluene.
Connection to the Power Supply
IMPORTANT:
Electrical installation
should comply with national and local
codes.
IMPORTANT:
This appliance must
be grounded!
WARNING:
Avoid fire hazard or
electrical shock. Do not use an adaptor
plug, an extension cord, or remove
grounding prong from electrical power
cord. Failure to follow this warning can
cause serious injury, fire or death.
This appliance is equipped with a 3-
prong grounding plug for your protection
against shock hazard and should be
plugged directly into a properly
grounded receptacle. DO NOT cut or
remove the grounding prong from this
plug.
For personal safety, the range must be
properly grounded. For maximum
safety, the power cord must be plugged
into an electrical outlet that is correctly
polarized and properly grounded.
If a 2-prong wall receptacle is the only
available outlet, it is the personal
responsibility of the consumer to have it
replaced with a properly grounded 3-
prong wall receptacle installed by a
qualified electrician.
WARNING:
Do not ground to a
gas pipe.
Our company shall not be held
responsible for any damage caused by
using the appliance without a grounded
receptacle.
The wiring diagram covering the control
circuit is located inside the lower panel,
below the oven door panels.
The power supply data must correspond
to the data specified on the rating plate
of the appliance. The rating plate is
seen when either the door or the lower
cover is opened.
20