12
ADJUSTING THE HEIGHT OF THE UNIT for MODELS SWC007 & ALWC15
The height of the unit can be increased by up to 3” by turning the adjustable legs. Once the desired height
has been achieved, the gap between the kick-plate and the floor can be covered by using a kick-plate
extender, which is described in the next section.
ADJUSTING THE KICK-PLATE for MODELS SWC007 & ALWC15
This appliance includes an adjustable kick-plate extender that is not
required to operate the unit. In order to adjust the kick-plate height,
follow the instructions below:
1. Remove the screws (1) from both the top left- and top right-hand
sides of the kick-plate installed on the unit.
2. Loose the screws (2) from both the bottom left- and bottom right-
hand sides of the kick-plate installed on the unit. Failure to
sufficiently loosen the bottom screws may cause damage to the
kick-plate extender when adjusting it.
3. Carefully guide the kick-plate extender down under the kick-plate until the desired height is achieved.
4. Tighten screws (2). Then reinsert screws (1) and tighten them
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required
to operate the unit. To install the handle, follow the instructions
below:
1. Remove the door gasket (2) on the side you wish to install the
handle - you can see two designated holes for handle
installation.
2. Install the handle (4) tightly as shown above with the two screws
(1) and flat washers (3) provided.
3. Replace the door gasket.
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (22º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The range of 41º-72ºF (5º-22ºC) may not be
reached.
