S CLASS™ cutter
User’s Manual
Detailed Operation
4-4
FlexCut:
FlexCut can be set to OFF, Fast, or Accurate. When the cutter is set to Fast or
Accurate, it will alternately cut a certain length with full pressure, and a certain length
with reduced pressure. The advantage of the FlexCut feature is that it cuts completely
through the material, yet allows the material to stay together by means of the small
media bridges.
Fast is the quickest mode, but it is less precise due to the pressure changes during
the cutting.
Accurate is much slower, but much more precise, as the cutter stops at every change
of pressure.
There are 3 typical FlexCut parameters:
1.
Full pressure cut length:
This parameter determines the length that is cut with
full pressure, usually the length that will be cut all the way through.
2.
Flex pressure cut length
: This parameter determines the length that will be cut
with reduced pressure or without pressure. This is usually a much smaller value
than the full pressure cut length – this is the length of the media bridges.
3.
FlexCut pressure:
This parameter determines the pressure of the Flex pressure
cut length. This is usually a reduced pressure so that the knife only scratches
the media or cuts it only halfway through.
Procedure to set the correct parameters for FlexCut:
1.
Press
then use
or
to choose
the FlexCut mode.
2.
Press
to confirm or
to cancel.
3.
Press
,
,
or
to select the parameter
that must be changed.
4.
Use
or
to change to the desired value, press
to confirm
or
to cancel.
5.
Go back to
and press
to check the result.
6.
Repeat steps 3 through 4 until the desired result is achieved.
Summary of Contents for S 75
Page 1: ...User s Manual Rev 05 05...
