USER MANUAL
Models SD-820 to SD-1710 with DDS
Rev 04 – October 2005
APPENDIX B
FLOW CAPACITY
B-1
APPENDIX B – DRYER FLOW CAPACITY
1. DRYER FLOW CAPACITY
The specific size/model of your dryer was selected to meet performance requirements
based on an analysis of air supply and demand capacities. The model selection chart
provided following should confirm that this dryer remains suitable for its intended use.
MODEL SELECTION CHART
Rated inlet air flow (scfm) at given pressures (psig)
(Based upon 100
o
F inlet air temperature)
MODEL
80
90
100
110
120
130
140
SD-820
640
735
820
890
960
1035
1105
SD-1050
830
960
1050
1215
1325
1410
1590
SD-1200
980
1095
1200
1305
1415
1520
1615
SD-1450
1110
1280
1450
1510
1700
1825
1950
SD-1710
1325
1515
1710
1810
1945
2080
2230
NOTE: Higher pressures available as an option. Consult factory
2. CORRECTION FACTOR FOR INLET TEMPERATURE
TEMP DEGREES F
80
90
100
105
110
115
120
Correction Factor
1.1
1.1
1.0
0.83
0.69
0.565
0.455
To correct for an inlet temperature other than 100°F multiply dryer capacity by the
temperature correction factor listed above.
Example
: To size for an inlet flow of 950 scfm @ 105°F and 110 psig.
Select models that produce at least 950 scfm at 110 psig. This case would be the
SD-1050 which can dry 1215 scfm.
Multiply pressure-corrected flow by the temperature correction factor to obtain
the flow of the dryer corrected for pressure and temperature:
1215 X (0.83) = 1008 scfm
Confirm model selection.
Model SD-1050 can flow 1008 scfm at the inlet
conditions specified. The requirement of 950 scfm is less, so model SD-1050 is
correct.
Summary of Contents for SD-1050 Series
