carried out in reverse order.
Only utilize tools and accessories which have
been approved by SUHNER.
The safety instructions issued by the tool manu-
facturer must also be observed.
Check that the diameter of the tool is within the permit-
ted limit and that the maximum permitted speed is higher
than the idle speed or set speed of the machine.
The assembled tool must be able to turn freely.
2.2 r
Ating
dAtA
Connection G35
Maximum speed Input
5’000min
-1
Max wheel diameter
175mm
Spindle Ø18
Vibration EN 60745
6.2m/s
2
, K=1.5m/s
2
Weight 3.300kg
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O
perAting
cOnditiOns
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
/ o
PERaTIoN
3.1 w
Orking
instructiOns
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s
witching
On/Off
Hold the hand tool firmly. Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4.1 p
reVentiVe
mAintenAnce
Always keep the hand tool clean and in a dry
place.
4. S
ERvICE
/ m
aINTENaNCE
4.2 r
epAir
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
tOrAge
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
ispOsAl
/ e
nVirOnmentAl
cOmpAtiBility
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
must be disposed of in an environmentally-compatible
recycling process.
17
