Page 32
5-4
#7040748 - Revision A - September, 2016
Component Removal
MODEL UW-24
MODEL UW-24
Kickplate
Base Cover
Figure 5-4. Base Cover Removal
Figure 5-5. SS Unit Wrap Removal
Slide Unit
Wrap for-
ward, then
lift up
Front Brackets
Remove
Back
Brackets
Exterior Wrap Components (Model UW-24FS ONLY)
Stainless Steel Base Cover Assemblies
-
The base
cover assemblies are stuck to the sides of the unit base
with double-stick tape. Screws passing through the
kickplate and the front flange of the base cover secure
the kickplate and covers to the unit base. To remove
the base cover assemblies, first remove the kickplate.
Then, at the back of the unit, insert a flat-blade screw-
driver between base cover and unit base and pry the
base cover off (See Figure 5-4).
Stainless Steel Unit Wrap
-
Brackets are riveted at
the front top and front sides of the unit. Flanges at front
of the unit wrap hook over these brackets. Brackets at
the back of the unit hook under the back flanges of the
unit wrap. When the mounting screws are tightened
down on the back brackets, they pull the wrap back-
ward, which holds the wrap tight between the front and
back brackets.
To remove the unit wrap (See Figure 5-5):
1.
Extract back bracket mounting screws and remove
back brackets.
2.
Slide unit wrap forward to disengage front brackets.
3.
Lift wrap up and off of unit.
