Subaru S209 2019, Service Manual

Page: 40 / 297

IN-10
Air Cleaner Case
INTAKE (INDUCTION)
4. Air Cleaner Case
A: REMOVAL
1) Disconnect the ground terminal from battery.
2) Remove the air intake duct.
3) Disconnect the connector (a) from the mass air
flow and intake air temperature sensor, and re-
move the harness clip (b).
4) Remove the engine coolant hose (c) from the air
intake boot, and loosen the clamp (d).
5) Remove the nut (e) of the air cleaner case brack-
et.
6) Remove the bolt (f), and then remove the air
cleaner case as a unit.
B: INSTALLATION
1) Set the air cleaner case and air intake duct as a
unit, and secure the air intake duct with clips.
2) Install the nut (a) of the air cleaner case bracket.
NOTE:
Tighten while pulling the air cleaner case bracket
(a) upward of the vehicle.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
3) Tighten the bolt (b).
Tightening torque:
6.5 N·m (0.7 kgf-m, 5.2 ft-lb)
4) Tighten the clamp (c) of the air intake boot, and
restore the engine coolant hose (d) to the original
position.
Tightening torque:
2.5 N·m (0.3 kgf-m, 1.8 ft-lb)
5) Connect the connector (e) to the mass air flow
and intake air temperature sensor, and install the
harness clip (f).
6) Connect the battery ground terminal.
C: INSPECTION
1) Check that the air cleaner case has no deforma-
tion, cracks or other damages.
2) Check that the air intake boot has no cracks,
damage or loose part.
(a)
(f)
(d)
(c)
(b) (e)
AA-15005
AA-15004
AA-15103
(a)
AA-15102
(e)
(c)
(d)
(f) (a)
(b)