– 33 –
9-4 ASSEMBLY PROCEDURES
9-4-1 FRONT PROTECTOR AND FRONT COVER
(1)
Attach the front protector to front cover.
The louvers of the front protector project into the inside of front cover.
5 ø × 10 mm Tapping screw....... 4 pcs.
Tightening torque: 3.4 ~ 5.4 N-m (35 ~ 55 kg-cm, 2.5 ~ 4 ft-lb)
(2)
Install the front cover to the engine. Apply
thread locking agent (Loctite 221 or Threeb-
ond 1342N) to the bolt as shown by the arrow
without fail.
8 ø × 20 mm bolt and washer assy
................................................... 4 pcs.
Tightening torque: 11.8 ~ 13.7 N-m (120 ~
140 kg-cm, 8.68 ~ 10.1 ft-lb)
NOTE 1: Insufficient thread locking agent
application could cause oil leak-
age.
NOTE 2: The size of faucet joint and pitch
of mounting holes of front cover
is different by models RGD3300H and RGD5000H.
9-4-2 ROTOR
(1)
Clean the tapered portion of driving shaft and
the matching tapered hole of rotor shaft of oil
and dirt using a waste cloth.
(2)
Attach rotor to the driving shaft.
Tighten through bolt with washer and spring
washer.
Tightening torque: 22.6 ~ 24.5 N-m (230 ~
250 kg-cm, 16.6 ~ 18.1ft-lb)
GENERATOR_GS2380.fm 33 ページ ２００７年１０月１日 月曜日 午前９時１３分
Summary of Contents for ROBIN RGD3300H
Page 1: ...SERVICE MANUAL RGD3300H RGD5000H GENERATORS Models PUB GS2380 Rev 06 08 ...
Page 2: ......
Page 53: ......
