3
Figure 4
Figure 5
Figure 6
5. Remove and retain for reinstallation, the black M8
bolt indicated by the arrow “A” in Figure 4. Loosen
the M8 bolt indicated by the arrow “B.”
8. Install the security module onto the bolt indicated by
the arrow “B” which was loosened in step 5, then
tighten the bolts indicated by the arrows “A” and
“B” to 13±3.6 ft. lbs. Refer to Figure 6.
NOTE: The security module must be properly
and firmly mounted. If it is not properly
and firmly installed, the system’s shock
sensor will not function as intended.
6. Route the male connector of the extension harness
under the center console from the driver’s seat side.
See Figure 5.
7. Insert the male connector of the extension harness
into the security module 18-pin connector.
