Engine Run-Time Changing Procedure
1 Cycle ×3
OPEN
CLOSE
1 Cycle
Answer-back
1. Remove the Driver's Side Under Cover.
2. Press the "ENGINE START STOP" Button twice to
switch ignition ON.
3. Connect the 1P SES Diagnostic Connectors.
4. Cycle the "ENGINE START STOP" Button from OFF
ACC IG ON 3 times, and check the number of
answer-back.
* The number of answer-back (simultaneous Hazard Lights
flash and Horn sound) will correspond to the current Engine
Run-Time.
* 1 answer-back : 3 minutes Engine Run-time
* 2 answer-backs: 10 minutes Engine Run-time
* 3 answer-backs: 15 minutes Engine Run-time
5. Open and close the Driver’s Side Door to change
the Engine Run-time setting.
The Engine Run-time will change as follows depending
on the number of times the Driver’s Side Door is
opened and closed (1 Cycle).
* 1 Cycle - 1 answer-back : 3 minutes Engine Run-time
* 2 Cycle - 2 answer-backs: 10 minutes Engine Run-time
* 3 Cycle - 3 answer-backs: 15 minutes Engine Run-time
* If you perform 4 Cycles or more, the Engine Run-time
setting and answer-back will continually repeat the above
1 to 3 pattern.
•
If registration of the Smart Engine Start ID is not
completed, the Smart Engine Start will not operate.
•
The Engine Run-time settings must adhere to state,
provincial, and local laws and regulations.
・
The initial Engine Run-Time setting is 15 minutes.
・
Wait until the answer-back horn stops sounding for
setting to complete before opening the door.
6. Turn the "ENGINE START STOP" Button to OFF.
7. Disconnect the 1P SES Diagnostic Connectors.
8. Secure the 1P SES Diagnostic Connectors using
Electrical Tape.
- 34 -
