Failure of the courtesy signal system.
In which case does the engine won’t stop?
Open a door, does the engine stop?
Please check +B, GND, IG using the wiring harness checks (page 33). Was the problem solved?
Replace the SES ECU and register again. If registration fails, replace the SES wiring harness.
Close the all doors, press the Unlock and then the Lock button on the car’s remote. Do the doors
lock and hazard lights work correctly?
Check the vehicle using the Subaru SSM. Are there any problems found?
The lock button was pushed and held more than
2 seconds, but engine did not stop.
See the car’s repair manual. Check the remote’s battery
might have run out.
Fix the vehicle problem first.
Replace SES ECU and register again. If Registration fails again, replace the SES Wiring Harness.
Open the hood. Did the engine stop?
Troubleshooting completed.
Press the "ENGINE START STOP" Button to stop the engine.
Contact Subaru for additional troubleshooting
information.
Check E
Yes
Yes
No
No
Yes
No
Yes
The door was opened
but engine did not stop.
Press the "ENGINE START STOP" Button to stop engine.
Refer to wiring harness checks on page 33, check +B, GND, IG. Was problem solved?
No
Yes
- 29 -
No
No
