Black plate (102,1)
北
米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
2-10
Keys and doors
pressed. These lights stay illuminated for
approximately 30 seconds if any of the
doors or the rear gate (Station wagon) is
not opened.
If the
“ ”
button is pressed before 30
seconds have elapsed, these lights will go
out.
To activate this function, set the following
interior light switches to the indicated
positions:
Map light:
OFF
position
Dome light:
Middle
position
Cargo area light:
DOOR
position
A SUBARU dealer can change the illumi-
nation period setting of the interior lights in
accordance with your preference. Contact
the nearest SUBARU dealer for details.
&
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
“ ”
button three times in a 5-second period
will cause your vehicle
’
s horn to sound
once and its turn signal lights to flash three
times.
NOTE
If the interval between presses is too
short when you press the
“ ”
button
three times, the system may not re-
spond to the signals from the remote
transmitter.
&
Sounding a panic alarm
To activate the alarm, press the
“
PANIC
”
button once.
The horn will sound and the turn signal
lights will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote transmitter is
pressed, the alarm will be deactivated
after approximately 30 seconds.
&
Selecting audible signal op-
eration
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Do the following to deactivate the audible
signal. You can also use the same steps
to restore the function.
1. Sit in the driver
’
s seat and shut all
doors and the rear gate.
2. Hold down the UNLOCK side of the
power door locking switch.
3. While holding down the
“
UNLOCK
”
side of the power door locking switch, pull
the key out and re-insert it into the ignition
switch at least 6 times within 10 seconds
after Step 2.
4. Open and close the driver
’
s door once
within 10 seconds after Step 3.
5. The turn signal lights flash 3 times to
indicate completion of the setting.
You may have the above settings done by
your SUBARU dealer.
&
Replacing the battery
CAUTION
.
Do not let dust, oil or water get on
or in the transmitter when repla-
cing the battery.
.
Be careful not to damage the
printed circuit board in the trans-
