Page 7
Model 315I (UC Ice Maker)
Installation Information
2-7
#3757320 - Revision B - August, 2005
Figure 2-8. Door Panel Drilling Template & Panel
Left-Hand Door Panel
Right-Hand Door Panel
Figure 2-9. Holes Drilled with Handle Side Bracket
When the reveal on the hinge side of the door panel is
less than 1/4”, use caution when closing the door as
severe finger pinching may occur.
Stainless Steel Door Panels
Stainless steel door panels are available from local
Sub-Zero distributors/dealers. There are two sizes:
• 15” W x 30-3/8” H x 3/4” T - (part #FP315SS)
• 17-3/4” W x 30-3/8” H x 3/4” T - (part #FP315SS-18)
These panels can be installed as left-hand or right-hand
swing and are equipped with stainless steel handles.
Custom Door Panel Specifications
The door panel specifications listed below are for units
installed in a standard 15-1/4” Wide x 33-3/4” High
rough opening. A minimum of 1/8” reveal should be
allowed around the edge of the panel along with a 4”
toe space.
• Door Panel Width .................................................. 15”
• Door Panel Height .......................................... 30-3/8”
• Door Panel Thickness .......................... 5/8” Minimum
• Door Panel Weight .......................... 15 lbs. Maximum
Door Panel Installation
NOTE:
For stainless steel panel, skip to step #4
1.
Place door panel face down on a protected surface,
making sure to not damage front of panel.
2.
Position plastic drilling template (provided with unit)
on back of door panel, flush with upper edge and
side of door panel.
NOTE:
The size of the panel shown in Figure 2-8 is
just large enough to cover the door. Actual door panel
sizes may vary depending on design/installation varia-
tions.
3.
Once proper position for mounting hardware has
been located, mark hole locations, remove drilling
template from door panel and drill pilot holes for
mounting hardware.
NOTE:
The location of the door handle should also be
determined at this time. It is recommended that the
position of the door handle be centered top to bottom
and towards the side of the panel opposite the hinges.
It may be necessary to countersink the handle mount-
ing holes so the screw heads do not interfere with the
panel fitting flush with the door.
4.
Remove handle-side door panel mounting bracket
from face of door and attach it to door panel with #8
x 1/2” screws, provided with unit.
5.
Install door panel on door by engaging tabs of han-
dle-side bracket with slots in face of door.
6.
Insert the #8 x 1/2” screws, provided with unit,
through top and bottom panel mounting brackets
into panel, then snug but do not tighten screws.
7.
Close door and align door panel with surrounding
cabinetry, then open door and tighten panel mount-
ing screws.
