Page 6
3.2 Mounting the TCV
This unit may be wall mounted, table mounted, beam mounted, suspended overhead,
pedestal mounted, or used without mounting. Mounting tabs are located on flanges on the
rear of the cabinet.
The mounting location should be in a stable, secure area so as to avoid damage to the unit
and avoid injury to the operator due to an inconvenient mounting. Locate the unit so that
ambient air can circulate freely around the cabinet.
This unit should be located to allow access to the front panel and connectors. The location
should allow for unrestricted and comfortable viewing of the front panel. The unit may be
remotely mounted, but should still be accessible.
3.3 Source
Power
CAUTION!
This unit is capable of being powered by 115 VAC
or 230 VAC (both 50 and 60Hz).
Before powering up the
unit for the first time, make sure the voltage selection on
the power entry module matches the type of power being
applied.
1. The voltage setting for the unit is always displayed in a
window above the power switch, shown as #1 in the
image to the right. Always check the voltage for compati-
bility before supplying electric power to the unit. For this
example the voltage will be changed from 115VAC to
230VAC.
2. If the setting needs to be changed because it does not match
the power to be supplied, open the access door marked as #2
in the prior image by prying outward gently with a fingernail or
small screwdriver. Slide the red voltage selector/fuse holder
out of the module.
Summary of Contents for TCV
Page 3: ......