55
B
865
785
Baugröße
1
2
B
mm
910
1360
Stützen
Stk
4
4
Rechteckprofile 70x40
Stk
4
4
Mafundstreifen
Stk
4
4
Schrauben M8x30
Stk
8
8
X
Z
Y
Z (min. 50)
Z (min. 800)
Z
(min. 50)
© STULZ GmbH – all rights reserved EN/09.2017/G44
cybercool indoor chiller original instructions
11. Options
11.1 Raised floor stand
The floor stand is used to adjust the height of the chiller to the existing raised floor and consists of an encir-
cling rectangular profile of galvanized steel with adjustable screw sockets. Anti vibration compound is recom-
mended between concrete floor and base plate.
Locating the supports
Cabinet size
B
mm
Supports
n°
Rectangular profiles 70x40
n°
Mafund strips
n°
Screws M8x30
n°
Mounting
Raised floor stand
X/Y = Opening in raised floor
Z = Limit of distance
• A concrete foundation is recommended in the
area of the raised floor supports.
• If the floor stand is placed near a wall, a minimum
distance of 50 mm must be respected. The gap
between wall and floor stand must be closed by
tin stripes.
• Choose the dimensions of the openings in the
raised floor (X and Y) 10 mm longer than the
raised floor stand dimensions.
• Close the joint with a continuous seal.
• The raised floor cutting (notch) should at
least be 15° and must not have any contact
to the raised floor stand, which could result in
bone-conduction.
• Install the raised floor supports on vibration
dampening material (Mafund plate) (do not screw
down the supports!).
• Prior to installation of the chiller, install the raised
floor 7 mm higher than the raised floor plates, as
the mafund plates are compressed by the weight
of the chiller.