17
Output busses
digiLiVE 16 allows to mix into 14 output busses in total – 4 Mono (Bus 1~4), 4 Stereo (Bus
5~8) and Master L/R. In fact, there is another stereo bus for monitoring through SOLO,
which can be switched as pre- or post-fader listen (PFL/AFL).
Press the BUS1-8 button on the front panel or swipe to the right side of the Stereo channels
on the display to switch to the BUS view of Busses 1-8. Another swipe to the right or
pressing the SEL button of the Master L/R will show the Master Layer:
While the left side of the page gives a full overview of all in- and outputs of the console, the
right side shows the Master L/R output strip, which in functionality follows exactly the stereo
Busses 5-8. The meter settings (pre- / post-fader) can be adjusted on the meter page in
Settings, which can be opened by yet another swipe to the right or by pressing the Settings
button on the front panel.
Each output buss contains 4 modules – Input stage, EQ, Input Source and Output Stage.
Except the Input Source, which is view-only, all other modules will bring up a sub-page if the
corresponding part in the screen is pressed. The sub-pages can be closed through the red
“close” button in the upper right corner.
