- 11 -
Cont ...
5 COMMISSIONING
5.11 The pump chamber must be full of water at all times. Damage will result if pump
runs dry.
5.12 The pump must be fully submerged before starting. Take care when submerging
the pump to ensure all air is purged from the casing. This is done by slowly
submerging the pump and gently agitating whilst doing so. This will enable any
trapped air pockets to be released.
5.13 Turn on the electrical supply and water movement should be immediately evident
from pump outlet. If it is not, repeat step 1.
5.14
For Further Technical Support:
Phone the Stuart Turner PumpAssist team on
+44 (0) 800 31 969 80. Our staff are trained to help and advise you over the
phone.
Note: When pumps are installed in another manufacturers original equipment,
please contact the manufacturer for advice.
