101176 REV E
27
Disassembly / Reassembly
HEATER ASSEMBLY
Perform the Steps for Reservoir and Upper Front & Rear Housing disassembly.
Remove the 2 wires from the Cartridge Heater. One goes to the PC-Board, the other goes to a neutral wiring connector.
Remove the (2) brass fittings on the bottom of the Tray assembly which holds the brass manifold block to the tray.
To assemble, reverse the disassembly steps. Special attention is required for the following:
1. Gray hose can be placed in warm water (<50°C) to facilitate installation on manifold fittings.
2. All o-rings must be seated. The reservoir o-ring is shaped, and shape must be aligned with the reservoir.
3. All fittings on the manifold should have teflon tape applied to prevent leaks.
4. Insure wires are cleared from between enclosures and away from enclosure screws.
5. Insure wires are routed away from the cooling fan blades.
6. For proper screw size and location for reservoir and housing, refer to parts illustration and replacement parts list.
7. Transfer the serial number to the new reservoir and cover with serial number label window.
8. When needed, the membrane ribbon must be routed as shown in Figure 11. This prevents interference between
the ribbon and moving components.
Figure 11: Ribbon Cable Routing
Membrane Ribbon
PCB Kit
Front Housing
