Stryker 521200380100, Operation & Maintenance Manual

Page: 22 / 136

E EM MC C iin nffo orrm ma attiio on n
W WA AR RN NIIN NG G
• Portable RF communications equipment, including peripherals such as antenna cables and external antennas, should
be no closer than 12 inches (30 cm) to any part of the S Se eccu urre e C Co on nn ne ecctt locator, including cables specified by the
manufacturer.
• Avoid stacking or placing equipment adjacent with other equipment to prevent improper operation of the product. If such
use is necessary, carefully observe stacked or adjacent equipment to make sure that they operate properly.
• The use of accessories, transducers, and cables, other than those specified or provided by the manufacturer, could
result in increased electromagnetic emissions or decreased electromagnetic immunity and result in improper operation.
The 521200380100 S Se eccu urre e C Co on nn ne ecctt locator was evaluated using the following cables:
C Ca ab blle e
L Le en ng gtth h ((m m))
AC mains input cable 1.2
Nurse call (DB-37) 2.4
G Gu uiid da an ncce e a an nd d m ma an nu uffa accttu urre err’’ss d de ecclla arra attiio on n -- e elle eccttrro om ma ag gn ne ettiicc e em miissssiio on nss
The 521200380100 S Se eccu urre e C Co on nn ne ecctt locator is intended for use in the electromagnetic environment specified below.
The customer or the user of the 521200380100 S Se eccu urre e C Co on nn ne ecctt locator should assure that it is used in such an
environment.
E Em miissssiio on nss tte esstt
C Co om mp plliia an ncce e E Elle eccttrro om ma ag gn ne ettiicc e en nvviirro on nm me en ntt
RF Emissions
CISPR 11
Group 1
N No otte e -- The emissions characteristics of this
equipment make it suitable for use in industrial areas
and hospitals (CISPR 11 class A). If it is used in a
residential environment (for which CISPR 11 class B
is normally required) this equipment might not offer
adequate protection to radio-frequency
communication services. The user might need to take
mitigation measures, such as relocating or re-
orienting the equipment.
RF Emissions
CISPR 11
Class A
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
G Gu uiid da an ncce e a an nd d m ma an nu uffa accttu urre err’’ss d de ecclla arra attiio on n -- e elle eccttrro om ma ag gn ne ettiicc iim mm mu un niittyy
The 521200380100 S Se eccu urre e C Co on nn ne ecctt locator is suitable for use in a professional healthcare facility environment and not
in environments exceeding immunity test conditions that the product was evaluated to, such as near high frequency (HF)
surgical equipment and inside of the radio frequency (RF) shielded room of magnetic resonance imaging (MRI)
equipment. The customer or the user of the 521200380100 S
Se eccu urre e C Co on nn ne ecctt locator should assure that it is used in such
an environment and that the electromagnetic environment guidance listed below is followed.
IIm mm mu un niittyy tte esstt
IIE EC C 6 60 06 60 01 1 tte esstt lle evve ell
C Co om mp plliia an ncce e lle evve ell
E Elle eccttrro om ma ag gn ne ettiicc
e en nvviirro on nm me en ntt--g gu uiid da an ncce e
Electrostatic Discharge
(ESD)
IEC 61000-4-2
±8 kV contact
±15 kV air
±8 kV contact
±15 kV air
Floors should be wood,
concrete, or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30%.
Electrostatic fast transient/
burst
IEC 61000-4-4
±2 kV for power supply lines
±1 kV for input/output lines
±2 kV for power supply lines
±1 kV for input/output lines
Main power quality should
be that of a typical
commercial or hospital
environment.
EN 18 5212-009-205 Rev AB.1