SG900
6
STEP 4
M A R K I N G M O U N T I N G F E E T L O C A T I O N S
Once you have determined the best location of the leg
sections and double checked all measurements, use a marker
to outline each foot. Be sure you only mark on the tape placed
on the deck in step 1. If using a permanent marker, be careful
not to get ink on the metal feet.
Keep the line as close to the outer perimeter of the foot as
possible. Later, you will need to re-align the feet with their
outline to begin drilling into the deck.
Repeat the outline process for each foot.
Note: The tape will be removed just before fastening
the t-top to the deck.
Position the lower halves of each side section on the deck. Make sure you take the same measurements
from the sides and aft of the boat for each side. Legs must be parallel to each other and square.
W h a t i s a S t a n d - O f f ?
Stand-offs provide additional support needed for your t-top.
They connect the legs of the t-top with your boat’s center console
unit on each side. You MUST use them!
