Stryker Medical Thermaltek 1030, Maintenance Manual

Page: 28 / 116

23
Service Information
DISPLAY BOARD REPLACEMENT (CONTINUED)
4. Using two 7/16” wrenches, remove the nuts, bolts and washers (items A, C & F, page 66) holding the display
assembly to the frame.
5. Using a 3/32” hex Allen wrench, remove the 6 set screws under the display weldment. Slide the display
board out toward the (patient) left.
6. Reverse the above steps to install the new display board. Thoroughly test all Modular Warmer operations
before returning the stretcher to service.
FILTER REPLACEMENT
The Thermaltek
t
warming system contains an inlet filter. It is recommended this filter be changed
every four to six months to ensure proper operation of the warming system. See the two blower box
diagrams below for filter part number and location.
Required Tools:
5/32” Hex Allen Wrench, 70825 Torx or Standard Screwdriver
FORMER STYLE
CURRENT STYLE
NOTE
Wire mesh on filter must face internally when installed.
CAUTION
To avoid electrical shock, unplug warmer or stretcher from wall socket before opening blower box.