TegraPol-11/ -15
TegraForce-1
Instruction Manual
31
Under normal operating conditions, it is recommended that the
contents of the TegraDoser bottles are not changed. It is better to
provide one doser per lubricant / suspension. However, if for any
reason the contents of a bottle must be changed or will not be in use
for a longer period of time, the following procedure can be used to
clean the TegraDoser:
Ensure that no preparation process is active.
Remove the TegraDoser from its mounting on the TegraForce.
Hold the TegraDoser vertically and open the snap lid on the top
of the bottle.
Empty the bottle of any remaining suspension or lubricant
through the hole in the top.
Fill the bottle with lukewarm water.
Mount the TegraDoser on the TegraForce.
Position a bottle under the outlet point of the TegraDoser. Press
and hold
or
until the soapy water has run through the
nozzle for approximately 1 min.
Remove the TegraDoser from the TegraForce and empty out the
soapy water remaining in the bottle.
Now repeat the rinsing process with the bottle fitted on the
TegraForce using clean tap water.
Remove the TegraDoser from the TegraForce and empty out the
clean water remaining in the bottle.
Fit the empty TegraDoser to the TegraForce. Press and hold
or
to empty the remaining water present in the nozzle.
The TegraDoser is now ready to be filled with a new suspension
or lubricant.
Cleaning TegraDoser-1