PART 1 • English
5
English
3.2 Connecting to TV and VCR
NOTE:
When connecting the receiver to other equipment, e.g., TV, VCR and amplifier, make sure to refer to relevant
user manual for instruction. Also, make sure you disconnect all the equipments from the mains supply before
the connection. (Fig. 5)
4.0 FIRST TIME INSTALLATION
After all the connections have been made properly, switch on your TV. Make sure the receiver is connected to the mains
and press Power to switch the receiver on. If you are using the receiver for the first time, a
Setup - Installation
menu will
be displayed to guide you through the initial setup. Use the remote control to finish the setup.
1. At the
Setup - Installation
menu, select in first step your regional settings, accordingly to your region and
settings you prefer.
2. Select then following settings
Antenna Power
,
Country Setting
,
OSD Language
,
Audio Language
,
Subtitle
Language
,
LCN
,
Time Zone
. If you use an active antenna please select
Antenna Power
to
ON
.
For well known countries where the
L
ogical
C
hannel
N
umbering is provided the LCN mode is
automatically set to
ON
, but if your country is providing LCN although, then you can switch
ON
. If you
aren't sure on that point please leave it switched
OFF
.
(Scr. 1) Press
q
to adjust time settings (Scr. 2)
NOTE:
Make sure to select the region you are located since the receiver will scan the channels based on the
bandwidth of the region you selected. If your region is not on the list, you are recommended to conduct a
manual search. Press
Manual Search
(
GREEN
) button on remote control.
3. Then select
Auto Scan
(
RED
) to proceed (Scr. 3)
4. Wait to complete the scanning.
In case you want to stop the scanning, press the
EXIT
key. The channels already found will still be stored.
(Scr. 4)
5. When finished, all channels found will be stored automatically. The first found channel will be played. Refer
to chapter Country Setting & Program Search. (Scr. 5)
Now you are ready to watch digital terrestrial TV channels and radio broadcasts.
In case you skip the
Setup - Installation
screen, you can still specify your
Country Settings
and
Program Search
via the
on-screen setup menu.
The
Country Setting
&
Program Search
menu can be accessed via
Main Menu
>
Installation
. Refer to chapter Country
Setting & Program Search.
5.0 BASIC OPERATIONS
Once program search is completed, you can start to watch digital terrestrial TV and radio channels. Some typical
operations are given in this chapter.
5.1 Switching On and Off
Whenever you are not using the receiver, press the
STANDBY
key on remote control to put it into standby mode.
5.2 Changing Channels
To switch between different channels, you can:
n
Press
OK
to display the channel list and
p
/
q
to select a desired channel.
n
Press the
p
/
q
key or buttons on the receiver to go to the previous/next channel.
n
Use the numeric keys to select a channel number.
n
Use the
RECALL
key to return to the previous viewed channel.
Whenever you change a channel, a banner appears at the bottom of the screen displaying the basic information on the
current channel. (Scr. 6)
5.3 Adjusting the Volume
Press the
t
/
u
key to adjust the volume. (Scr. 7)
Summary of Contents for PRIMA III
