Adjusting the
complete cam
block
NOTE
A block adjustment is offered when the adjusted individual switching points should
not be altered to each other, for example, when the wire length is changed. With a
block adjustment, the relative adjustment of the individual contacts to each other
remains unchanged.
1. Loosen the nut (5).
2. Turn the complete switching block by hand to the required switching position.
3. Tighten the nut (5) to a tightening torque of 2,5 Nm.
4. Mount the cover of the GTES, see section 6.7.
6.7
Mount the cover
NOTE
The screws must be fully screwed in.
Assembly of the
cover
When fitting the cover, ensure that the screws are fully
and uniformly tightened in order to avoid tilting the cov-
er and poor contact pressure of the seal.
1. Check the seal (3) on the cover (2) for cracks or
damage.
NOTE
Replace damaged seals.
2. Fit the cover with the seal.
NOTE
The screws must be fully screwed in.
3. Fix the cover with 4 screws (1) and washers, see
EKM-0126
33
22
11
Fig. 23
6.8
Correct disposal/recycling of operating and auxiliary materials.
Materials that can be recycled must be included in the waste disposal cycle.
Local regulations in the country of operation determine the disposal of components.
7 Operation
7.1
Special safety guidelines.
See operating instructions of the machine.
7.2
Initial commissioning
The adjustment of the GTES is only permitted when the machine is at a standstill.
7.3
Use
Use of the GTES is not necessary, see the operating instructions of the machine.
37
Mounting/operating instructions Gear limit switch Type series HGE • No. 152-00000 F • 10/2017
