Strobel 3200D series, Operating Instructions Manual

Page: 13 / 40

9
BA_3200D_A1_140203_en
3
3.1
Set-up and commissioning
Strobel machines are supplied either complete as upper part with motor or as
upper part only.
Unpacking of the machine
With complete delivery the machines are subdivided in smaller packing units
due to the great weight and to prevent transport damages.
The upper part is unscrewed form the frame. The cotton stands, rod system, oil
and further machine accessories are located in the frame packing.
Prior to disposing of the packing material it must be carefully checked whether
all accessories parts have been unpacked.
3.2 Setting up the machine (Fig. 1)
C A U T I O N ! Danger of injury!
Due to pulling in of parts of clothing or hair as well as
danger of crushing of fingers!
The machine must not be operated without a guard for the
belt for the upper part and for the motor.
Screw the upper part to the table plate. (Fig. 2)
The bolts 135.0187 and the pressure spring 161.0176 are enclosed with the
machine accessories and must be fitted as shown in Fig. 2.
The pedal rod system must be suspended according to Fig. 1
.
Push on the knee lever and secure with knurled screw. (not necessary with
pneumatic venting, see also point “3.5 Intermediate venting (Fig. 5)”)
The cotton stand is mounted at the back on the right on the table plate after
assembly of the individual parts.
Check all screws at the frame for tight fit and retighten if necessary.
A T T E N T I O N !
Prior to commissioning the machine it must be checked
whether the electric connection data on the type plate of the
motor, especially the network voltage and the frequency,
are according to the data of your current network.
All rust prevention agents, such as Vaseline or similar, must be carefully
removed from the sewing tools prior to commissioning the machine.