User manual
Quick start
2
Welcome to Immersive Learning with Strivr. Let’s look at quick steps to get up and running:
1. Unbox your gear
In each headset box, you’ll find a VR headset with a controller attached by a tether, plus a charge cable, wall
adapter, and batteries. In a separate accessory bag, you’ll find a dry lens-cleaning cloth and a bag of wet
disinfecting wipes. Take the headset out and peel off the protective lens covers.
2. Install controller batteries
Slide the bottom of the controller down to open the battery compartment and insert the batteries.
3. Charge your headsets
Charge headsets for about 2 hours, or until the indicator light turns green. If you have a USB hub, plug each
headset into a USB port on the hub and plug the hub into a wall adapter. If your system includes a Management
Device (MD), see “System setup” on page 14.
4. Connect to wi-fi*
Put the headset on and wake the controller by holding the home button. Hold Trackpad UP + Trigger to open
the Wi-Fi screen. On the wi-fi screen, make sure Wi-Fi is set to On. Then select your network, key in the
password, and return to training.
* NOTES:
If your company uses a Mobile Device Manager like Workspace ONE, headsets should connect
automatically once Wi-Fi is set to On.
Connecting to Wi-Fi is only necessary the first time you use a headset at a new location.
If your company uses Oculus Go headsets, headsets should connect automatically.
If your system includes an MD, headsets connect through the MD and wi-fi setup in the headset is not
necessary—see “System setup” on page 14.
Quick start
