27
Mounting the bracket using a screw:
Installing this Disco Ball Effect Sphere is very easy. If you have the right tools, it should work. Read the
instructions carefully before mounting.
Necessities:
-
The Disco Ball Effect Sphere
-
The bracket
-
The 2 nuts for the bracket
-
A pencil
-
A tape measure.
-
An impact drill with the correct drill bit (refer to step 2 and 3)
-
A nylon plug (not included)
-
One screw (not included)
-
One ring (not included)
-
A screwdriver
-
Safety glasses
-
The manual
-
A vacuum cleaner (for cleaning up all the mess)
Step 1: Determine the correct mounting position
Mea marking the drill position are by far the most important steps.
Make sure that the hole you are going to make in the wall or ceiling is measured very precisely.
Mark the drill hole with a pencil.
Place the Disco Ball Effect Sphere close to an outlet that is easily accessible. The cable length
is only 1.2m.
Step 2: Determine the Right Plug, Screw, and Drill
Follow the table below to select the appropriate nylon plug and screw (for use in concrete or solid
bricks).
Nylon plug
Diameter x length
(in mm)
Depth
drill hole
(in mm)
Drill bit
diameter
(in mm)
Maximum
tensile force
(in kg) *
Screw
diameter
(in mm)
4x20
25
4
10*
3
5x25
30
5
25*
2,5 - 4
6x30
35
6
60*
3,5 - 5
* Note:
the maximum tensile force is of course dependent on the strength of the stone and the quality of
the plug. This tensile force is calculated on the upright pulling out of the plug with the recommended
screw thickness. Screw length is also a factor that can determine the pulling force.
